300 Size

300XT Brushless Motor 1300 RPM These brushless motors are radically powerful and they are efficient — longer flights on a charge. But there’s another aspect that’s better, they give a different "feel" to the flying of the model airplane: At half throttle, you’ll feel that the motor is silently pulling the airplane through the air at flying speeds — effortlessly. Then when you open the throttle to FULL you’ll see your airplane shoot ahead like you’ve never seen before — effortlessly and silently. You are seeing and "feeling" raw, silent power. It is mysterious. It is flight without limits. An excellent motor for the small indoor flyer such as the Ikarus Shock Flyers . Suitable for 2 or 3 lithium polymer cells operation.   Specifications: Body Diameter: 25.6mm. Body Length: 17.7mm. Weight: 26g   SMC-M-APMBL301 Specifications: Battery Pack: 2-3 Lithium polymer cells Curent: 4 Amps continuous KV: 1300 rpm per Volt Shaft: 3.0mm Propeller: (Direct Drive) 7×4 to 8×6  We have done extensive testing on this motor and are really excited about putting it into action in some of our IFO’s, Tiger Moths (can you say 3D Tiger Moth), PT-17, and any plane 12 oz’s or less should go 3D! The motor has been tested and works well with two and three LiPo cells in series. I like them on three LiPos ! A two cell runs between 6 and 8.4 volts. A three cell runs between 9 and 12.6 volts, depending on the state of charge. See the Tech Chart to figure out what type of performance you’ll get with these motors.

300DF Brushless Motor 2250 RPM The 300DF is a light motor, designed to fly park flyers. Use the 300DF with a 3:1 or gearbox and large prop 8×4, or a speed demon on a 5×3 inch or smaller prop. 2 cell Lipo or 3 cell Lipo can be used with all this motor, but best performance can be achieved by using 3 cells+4.5:1 gear ratio with 12X6, or 11X7 or 11X4.7 props. The data for other props and gears: For 3.4:1 gearing use 11×7 HD, 11×4.7 SF For 4.5:1 gearing use 12×6, 11X4.7, 11X7 SF 300DF pusher props have proven to be spectacular. It has been flown with Wing Warrior Zaggis, Wattage HyperWing and Edge RC delta wing planes . Using a small prop direct drive and wings around 16 Oz weight, this is the best you can get at this price. With a 5×4 prop it draws about 12 amps. It is equally good with large props in a gearbox. So decide whether you want speed – 50+ MPH or slow fly with large props and a lot of torque and use this motor for both. Specifications: Max Current: 10 Amps. KV: 2250 Shaft Diameter: 2.3 cm Weight: 29.7 g Mount Holes: Standard 16.5 & 19.5 We have done extensive testing on this motor and are really excited about putting it into action in some of our IFO’s, Tiger Moths (can you say 3D Tiger Moth), PT-17, and any plane 12 oz’s or less should go 3D! The motor has been tested and works well with two and three LiPo cells in series. I like them on three LiPos ! A two cell runs between 6 and 8.4 volts. A three cell runs between 9 and 12.6 volts, depending on the state of charge. See the Tech Chart to figure out what type of performance you’ll get with these motors.