AEO SERVO EXPANSION X2 is designed for FPV gyro tracking system to extend the moving range of servo on the camera mount. It changes movement characteristics of traditional RC servo to meet the movement request of camera mount. SERVO EXPANSION X2 also can be used in other RC areas, making servo move in a wide range and adjusting the movement way and position of Servo directly to control the servo precisely Application Able to adjust moving buffer and reduce moving impact. For example, can reduce the image shaking caused by movement of servo in the FPV video transmission system. Able to adjust the moving range of servo to reach l arger moving angle (such as 180° ) or reduce the moving range. Traditionally if the servo input signal received by receiver exceeds the standard, the receiving system will disorders (such as signal lost and so on). Before this, can do the signal expansion. Able to calibrate and trim the midpoint of servo quickly. In a FPV system, as the midpoint of servo may be different from that needed in practical use, this product can meet this need to calibrate and trim it. Setting introduction: Supply power and press setting button 5 seconds to enter into setting mode. LED flashing means main setting menu opened. Main menu Second menu Flashing times Function Flashing times Function ● *1 Moving buffer ● *1 - ● *9 Set the degree of buffer ● *2 ?A?channel servo moving rate adjust ● *1 50% of original ● *2 100% of original ● *3 200% of original reach the limit position ● *3 ?B?channel servo moving rate adjust ● *1 50% of original ● *2 100% of original ● *3 200% of original reach the limit position ● *4 Set servo midpoint ● *5 Servo trimming ● *6 Servo limit position setting ● *7 Servo limit position ● *8 ----- ● *9 ----- When you adjust the options you need a good, long press the button automatically save and exit this menu and switch to the next big menu options. When you come after all the power can be adjusted. the LED flashes as above table shown in the main menu. Flashing once means function 1, flashing twice means function 2, and so on. Jump to the next option by pressing the button no more than 1 second and choose this one by pressing it no less than 3 seconds. Save and exit menu by pressing the button for a long enough time after setting completed, the next option in the main menu opened at the same time. Turn off the power after all adjusted well. Function introduction: Flashing once: moving buffer. Moving buffer function can balance the movement of servo to reduce the shake and smooth the movement. For example, need to increase the buffer and reduce the shake when carrying a large camera. After entering into this option, That flashing once means no buffer and flashing ninth means the largest buffer. Flashing twice: ?A? channel s